AI Act
Table of Contents
Chapter I – GENERAL PROVISIONS
Chapter II – PROHIBITED AI PRACTICES
Chapter III – HIGH-RISK AI SYSTEMS
Chapter IV – TRANSPARENCY OBLIGATIONS FOR PROVIDERS AND DEPLOYERS OF CERTAIN AI SYSTEMS
Chapter V – GENERAL-PURPOSE AI MODELS
Chapter VI – MEASURES IN SUPPORT OF INNOVATION
Chapter VII – GOVERNANCE
Chapter VIII – EU DATABASE FOR HIGH-RISK AI SYSTEMS
Chapter IX – POST-MARKET MONITORING, INFORMATION SHARING AND MARKET SURVEILLANCE
Chapter X – CODES OF CONDUCT AND GUIDELINES
Chapter XI – DELEGATION OF POWER AND COMMITTEE PROCEDURE
Chapter XII – PENALTIES
Chapter XIII – FINAL PROVISIONS
Recitals (180)
Annexes
Recital 121
(121) Standardisation should play a key role to provide technical solutions to providers to ensure compliance with this Regulation, in line with the state of the art, to promote innovation as well as competitiveness and growth in the single market. Compliance with harmonised standards as defined in Article 2, point (1)(c), of European Standardisation Regulation of the European Parliament and of the Council ( 41 ) , which are normally expected to reflect the state of the art, should be a means for providers to demonstrate conformity with the requirements of this Regulation. A balanced representation of interests involving all relevant stakeholders in the development of standards, in particular SMEs, consumer organisations and environmental and social stakeholders in accordance with Articles 5 and 6 of European Standardisation Regulation should therefore be encouraged. In order to facilitate compliance, the standardisation requests should be issued by the Commission without undue delay. When preparing the standardisation request, the Commission should consult the advisory forum and the Board in order to collect relevant expertise. However, in the absence of relevant references to harmonised standards, the Commission should be able to establish, via implementing acts, and after consultation of the advisory forum, common specifications for certain requirements under this Regulation. The common specification should be an exceptional fall back solution to facilitate the provider’s obligation to comply with the requirements of this Regulation, when the standardisation request has not been accepted by any of the European standardisation organisations, or when the relevant harmonised standards insufficiently address fundamental rights concerns, or when the harmonised standards do not comply with the request, or when there are delays in the adoption of an appropriate harmonised standard. Where such a delay in the adoption of a harmonised standard is due to the technical complexity of that standard, this should be considered by the Commission before contemplating the establishment of common specifications. When developing common specifications, the Commission is encouraged to cooperate with international partners and international standardisation bodies.